Search results
Results from the Health.Zone Content Network
The DHCP server permanently assigns an IP address to a requesting client from a range defined by an administrator. This is like dynamic allocation, but the DHCP server keeps a table of past IP address assignments, so that it can preferentially assign to a client the same IP address that the client previously had. Manual allocation
A network administrator may configure DHCP by allocating specific IP addresses based on MAC address. DHCP is not the only technology used to assign IP addresses dynamically. Bootstrap Protocol is a similar protocol and predecessor to DHCP. Dialup and some broadband networks use dynamic address features of the Point-to-Point Protocol.
The Dynamic Host Configuration Protocol version 6 ( DHCPv6) is a network protocol for configuring Internet Protocol version 6 (IPv6) hosts with IP addresses, IP prefixes, default route, local segment MTU, and other configuration data required to operate in an IPv6 network. It is not just the IPv6 equivalent of the Dynamic Host Configuration ...
Used for loopback addresses to the local host: 169.254.0.0/16 169.254.0.0–169.254.255.255 65 536: Subnet Used for link-local addresses between two hosts on a single link when no IP address is otherwise specified, such as would have normally been retrieved from a DHCP server 172.16.0.0/12 172.16.0.0–172.31.255.255 1 048 576: Private network
A rogue DHCP server is a DHCP server on a network which is not under the administrative control of the network staff. It is a network device such as a modem or a router connected to the network by a user who may be either unaware of the consequences of their actions or may be knowingly using it for network attacks such as man in the middle.
Zero-configuration networking. Zero-configuration networking ( zeroconf) is a set of technologies that automatically creates a usable computer network based on the Internet Protocol Suite (TCP/IP) when computers or network peripherals are interconnected. It does not require manual operator intervention or special configuration servers.
The gateway address may be added manually. On Windows computers, the gateway address is configured using the TCP/IP Properties. The gateway address can be automatically determined using Dynamic Host Configuration Protocol (DHCP). DHCP allows a host to obtain network information from a server. The host contacts the server to obtain an IP address ...
These addresses are not routable. Like private addresses, these addresses cannot be the source or destination of packets traversing the internet. These addresses are primarily used for address autoconfiguration when a host cannot obtain an IP address from a DHCP server or other internal configuration methods.