Search results
Results from the Health.Zone Content Network
Time to live ( TTL) or hop limit is a mechanism which limits the lifespan or lifetime of data in a computer or network. TTL may be implemented as a counter or timestamp attached to or embedded in the data. Once the prescribed event count or timespan has elapsed, data is discarded or revalidated. In computer networking, TTL prevents a data ...
Country code top-level domain. A country code top-level domain ( ccTLD) is an Internet top-level domain generally used or reserved for a country, sovereign state, or dependent territory identified with a country code. All ASCII ccTLD identifiers are two letters long, and all two-letter top-level domains are ccTLDs.
Hop (networking) An illustration of hops in a wired network (assuming a 0-origin hop count [1] ). The hop count between the computers in this case is 2. In wired computer networking a hop occurs when a packet is passed from one network segment to the next. Data packets pass through routers as they travel between source and destination.
For example, every device (such as an intermediate router) forwarding an IP datagram first decrements the time to live (TTL) field in the IP header by one. If the resulting TTL is 0, the packet is discarded and an ICMP time exceeded message is sent to the datagram's source address. Many commonly used network utilities are based on ICMP messages.
A logic family of monolithic digital integrated circuit devices is a group of electronic logic gates constructed using one of several different designs, usually with compatible logic levels and power supply characteristics within a family. Many logic families were produced as individual components, each containing one or a few related basic ...
tracert. In computing, traceroute and tracert are diagnostic command-line interface commands for displaying possible routes (paths) and transit delays of packets across an Internet Protocol (IP) network. The command reports the round-trip times of the packets received from each successive host (remote node) along the route to a destination.
It is specified in seconds, but time intervals less than 1 second are rounded up to 1. In practice, the field is used as a hop count—when the datagram arrives at a router, the router decrements the TTL field by one. When the TTL field hits zero, the router discards the packet and typically sends an ICMP time exceeded message to the sender.
Change the outbound TTL to 255 for its protocol connection; If the protocol is a configured protocol peer. Set the Access Control List (ACL) to allow packets of the given protocol to only pass to the route processor (RP). The TTL must be set to either 255 if the destination is directly connect or 255 minus the range of acceptable hops if not ...