Search results
Results from the Health.Zone Content Network
In batteries, the cut-off (final) voltage is the prescribed lower-limit voltage at which battery discharge is considered complete. The cut-off voltage is usually chosen so that the maximum useful capacity of the battery is achieved. The cut-off voltage is different from one battery to the other and it is highly dependent on the type of battery ...
In electronics, cutoff frequency or corner frequency is the frequency either above or below which the power output of a circuit, such as a line, amplifier, or electronic filter has fallen to a given proportion of the power in the passband. Most frequently this proportion is one half the passband power, also referred to as the 3 dB point since a ...
In electronics, cut-off is a state of negligible conduction that is a property of several types of electronic components when a control parameter (that usually is a well-defined voltage or electric current, but could also be an incident light intensity or a magnetic field ), is lowered or increased past a value (the conduction threshold).
Half-power point. The half-power point is the point at which the output power has dropped to half of its peak value; that is, at a level of approximately −3 dB. [1][a] In filters, optical filters, and electronic amplifiers, [2] the half-power point is also known as half-power bandwidth and is a commonly used definition for the cutoff ...
The "neck" of this eight-like figure is a cut-point. In topology, a cut-point is a point of a connected space such that its removal causes the resulting space to be disconnected. If removal of a point doesn't result in disconnected spaces, this point is called a non-cut point. For example, every point of a line is a cut-point, while no point of ...
A high-pass filter (HPF) is an electronic filter that passes signals with a frequency higher than a certain cutoff frequency and attenuates signals with frequencies lower than the cutoff frequency. The amount of attenuation for each frequency depends on the filter design. A high-pass filter is usually modeled as a linear time-invariant system.
Fractional flow reserve is defined as the pressure after (distal to) a stenosis relative to the pressure before the stenosis. [2] The result is an absolute number; an FFR of 0.80 means that a given stenosis causes a 20% drop in blood pressure. In other words, FFR expresses the maximal flow down a vessel in the presence of a stenosis compared to ...
Cutoff (physics) In theoretical physics, cutoff (AE: cutoff, BE: cut-off) is an arbitrary maximal or minimal value of energy, momentum, or length, used in order that objects with larger or smaller values than these physical quantities are ignored in some calculation. It is usually represented within a particular energy or length scale, such as ...