Health.Zone Web Search

Search results

1. Results from the Health.Zone Content Network

2. Static routing - Wikipedia

   https://en.wikipedia.org/wiki/Static_routing

   Static routing. Static routing is a form of routing that occurs when a router uses a manually-configured routing entry, rather than information from dynamic routing traffic. [1] In many cases, static routes are manually configured by a network administrator by adding in entries into a routing table, though this may not always be the case. [2]

3. Wireless onion router - Wikipedia

   https://en.wikipedia.org/wiki/Wireless_onion_router

   A wireless onion router is a router that uses Tor to connect securely to a network. The onion router [1] allows the user to connect to the internet anonymously creating an anonymous connection. Tor works using an overlaid network which is free throughout the world, this overlay network is created by using numerous relay [2] points created using ...

4. Anycast - Wikipedia

   https://en.wikipedia.org/wiki/Anycast

   Anycast delivers a message to any one out of a group of nodes, typically the one nearest to the source using a one-to-one-of-many [1] association where datagrams are routed to any single member of a group of potential receivers that are all identified by the same destination address. The routing algorithm selects the single receiver from the ...

5. NetFlow - Wikipedia

   https://en.wikipedia.org/wiki/NetFlow

   NetFlow. NetFlow is a feature that was introduced on Cisco routers around 1996 that provides the ability to collect IP network traffic as it enters or exits an interface. By analyzing the data provided by NetFlow, a network administrator can determine things such as the source and destination of traffic, class of service, and the causes of ...

6. Wireless repeater - Wikipedia

   https://en.wikipedia.org/wiki/Wireless_repeater

   A Wi-Fi Repeater. A wireless repeater (also called wireless range extender or wifi extender) is a device that takes an existing signal from a wireless router or wireless access point and rebroadcasts it to create a second network. When two or more hosts have to be connected with one another over the IEEE 802.11 protocol and the distance is too ...

7. Routing loop - Wikipedia

   https://en.wikipedia.org/wiki/Routing_loop

   In a naive distance-vector protocol, such as the routing information protocol, the loop will persist until the metrics for C reach infinity (the maximum number of routers that a packet can traverse in RIP is 15. The value 16 is considered infinity and the packet is discarded). Prevention and mitigations

8. Port triggering - Wikipedia

   https://en.wikipedia.org/wiki/Port_triggering

   Port triggering is a configuration option on a NAT-enabled router that controls communication between internal and external host machines in an IP network. It is similar to port forwarding in that it enables incoming traffic to be forwarded to a specific internal host machine, although the forwarded port is not open permanently and the target internal host machine is chosen dynamically.

9. Routing table - Wikipedia

   https://en.wikipedia.org/wiki/Routing_table

   In computer networking, a routing table, or routing information base ( RIB ), is a data table stored in a router or a network host that lists the routes to particular network destinations, and in some cases, metrics (distances) associated with those routes. The routing table contains information about the topology of the network immediately ...