Health.Zone Web Search

Search results

  1. Results from the Health.Zone Content Network
  2. IEEE 802.1Q - Wikipedia

    en.wikipedia.org/wiki/IEEE_802.1Q

    IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.

  3. VLAN - Wikipedia

    en.wikipedia.org/wiki/VLAN

    VLAN cross connect (CC or VLAN-XC) is a mechanism used to create Switched VLANs, VLAN CC uses IEEE 802.1ad frames where the S Tag is used as a Label as in MPLS. IEEE approves the use of such a mechanism in part 6.11 of IEEE 802.1ad-2005 .

  4. IEEE 802.1ad - Wikipedia

    en.wikipedia.org/wiki/IEEE_802.1ad

    IEEE 802.1ad is an amendment to the IEEE 802.1Q-1998 networking standard which adds support for provider bridges. It was incorporated into the base 802.1Q standard in 2011. [1] The technique specified by the standard is known informally as stacked VLANs or QinQ . The original 802.1Q specification allows a single virtual local area network (VLAN ...

  5. VLAN hopping - Wikipedia

    en.wikipedia.org/wiki/VLAN_hopping

    VLAN hopping. VLAN hopping is a computer security exploit, a method of attacking networked resources on a virtual LAN (VLAN). The basic concept behind all VLAN hopping attacks is for an attacking host on a VLAN to gain access to traffic on other VLANs that would normally not be accessible. There are two primary methods of VLAN hopping: switch ...

  6. Ethernet frame - Wikipedia

    en.wikipedia.org/wiki/Ethernet_frame

    The IEEE 802.1Q tag or IEEE 802.1ad tag, if present, is a four-octet field that indicates virtual LAN (VLAN) membership and IEEE 802.1p priority. The first two octets of the tag are called the T ag P rotocol ID entifier (TPID) and double as the EtherType field indicating that the frame is either 802.1Q or 802.1ad tagged. 802.1Q uses a TPID of ...

  7. EtherType - Wikipedia

    en.wikipedia.org/wiki/EtherType

    EtherType. EtherType is a two- octet field in an Ethernet frame. It is used to indicate which protocol is encapsulated in the payload of the frame and is used at the receiving end by the data link layer to determine how the payload is processed. The same field is also used to indicate the size of some Ethernet frames.

  8. Cisco Inter-Switch Link - Wikipedia

    en.wikipedia.org/wiki/Cisco_Inter-Switch_Link

    Cisco Inter-Switch Link. Cisco Inter-Switch Link ( ISL) is a Cisco proprietary link layer protocol that maintains VLAN information in Ethernet frames as traffic flows between switches and routers, or switches and switches. [1] ISL is Cisco's VLAN encapsulation protocol and is supported only on some Cisco equipment over the Fast and Gigabit ...

  9. IEEE P802.1p - Wikipedia

    en.wikipedia.org/wiki/IEEE_P802.1p

    IEEE P802.1p. IEEE P802.1p was a task group active from 1995 to 1998, responsible for adding traffic class expediting and dynamic multicast filtering to the IEEE 802.1D standard. The task group developed a mechanism for implementing quality of service (QoS) at the media access control (MAC) level. Although this technique is commonly referred to ...