Search results
Results from the Health.Zone Content Network
Ethernet. The Point-to-Point Protocol over Ethernet ( PPPoE) is a network protocol for encapsulating Point-to-Point Protocol (PPP) frames inside Ethernet frames. It appeared in 1999, in the context of the boom of DSL as the solution for tunneling packets over the DSL connection to the ISP 's IP network, and from there to the rest of the Internet.
IPoE. Internet Protocol over Ethernet ( IPoE) is a method of delivering an IP payload over an Ethernet -based access network or an access network using bridged Ethernet over Asynchronous Transfer Mode (ATM) without using PPPoE. It directly encapsulates the IP datagrams in Ethernet frames, using the standard RFC 894 encapsulation . The use of ...
In computer networking, Point-to-Point Protocol ( PPP) is a data link layer (layer 2) communication protocol between two routers directly without any host or any other networking in between. It can provide loop detection, authentication, transmission encryption, [1] and data compression . PPP is used over many types of physical networks ...
v. t. e. The Dynamic Host Configuration Protocol ( DHCP) is a network management protocol used on Internet Protocol (IP) networks for automatically assigning IP addresses and other communication parameters to devices connected to the network using a client–server architecture. [1]
This is a list of the IP protocol numbers found in the field Protocol of the IPv4 header and the Next Header field of the IPv6 header.It is an identifier for the encapsulated protocol and determines the layout of the data that immediately follows the header.
EtherType. EtherType is a two- octet field in an Ethernet frame. It is used to indicate which protocol is encapsulated in the payload of the frame and is used at the receiving end by the data link layer to determine how the payload is processed. The same field is also used to indicate the size of some Ethernet frames.
In computer networking, Internet Protocol Control Protocol ( IPCP) is a Network Control Protocol (NCP) for establishing and configuring Internet Protocol over a Point-to-Point Protocol link. IPCP is responsible for configuring the IP addresses as well as for enabling and disabling the IP protocol modules on both ends of the point-to-point link.
Internet Connection Sharing ( ICS) is a Windows service that enables one Internet -connected computer to share its Internet connection with other computers on a local area network (LAN). The computer that shares its Internet connection serves as a gateway device, meaning that all traffic between other computers and the Internet go through this ...