Search results
Results from the Health.Zone Content Network
Candidates for admission to the B.Tech. Degree course shall be required to have passed the higher secondary/+2/XII Std. examination conducted by boards/departments recognized/accepted by the university, obtaining not less than 50% marks in Mathematics and not less than 50% marks in Mathematics, Physics and Chemistry put together or the diploma examination in Engineering, Kerala or any ...
A center punch is used to mark the center of a point. It is usually used to mark the center of a hole when drilling holes. A drill has the tendency to "wander" if it does not start in a recess. A center punch forms a large enough dimple to "guide" the tip of the drill. The tip of a center punch has an angle between 60 and 90 degrees. [1]
In the United States, surface finish is usually specified using the ASME Y14.36M standard. The other common standard is International Organization for Standardization (ISO) 1302:2002, although the same has been withdrawn in favour of ISO 21920-1:2021.
The Lackawanna Cut-Off Restoration Project is a New Jersey Transit and Amtrak effort to restore passenger service to the Lackawanna Cut-Off in northwest New Jersey.. Started in 2011, Phase 1 of the project is extending NJ Transit's commuter rail service 7.3 miles (11.7 km) from Port Morris Junction in Morris County to Andover in Sussex County, with the latter seeing its first passenger trains ...
A datum reference or just datum (plural: datums [Note 1]) is some important part of an object—such as a point, line, plane, hole, set of holes, or pair of surfaces—that serves as a reference in defining the geometry of the object and (often) in measuring aspects of the actual geometry to assess how closely they match with the nominal value, which may be an ideal, standard, average, or ...
An order from the engineering department (to be followed by the production department or vendor) overriding/superseding a detail on the drawing, which gets superseded with revised information. Also called by various other names, such as engineering change order (ECO), engineering change notice (ECN), drawing change notice (DCN), and so on.
The cutoff marks in the exam is divided into four categories based on the groups of people and castes in India. Cutoffs were reduced in 2020. For General candidates it is 30th percentile, for general but PwD candidates it is a25th percentile, for both SC/ST/OBC and PwD under SC/ST/OBC, it is 20th percentile. [7]
With educational reforms in 1972, the Institute of Engineering was formed under Tribhuvan University, integrating with the engineering institute in Thapathali. Since then, Pulchowk Campus has flourished, offering a diverse array of programs including certificates, bachelor’s, master’s, and Ph.D. degrees across engineering disciplines like ...